Filter
Top Products
6
1. Make sure that the power cord is unplugged.
Place a piece of cardboard under the tread-
mill frame to protect the floor during assem-
bly.
Have a second person hold the Base (52) in the
position shown.
Attach six Base Feet (63) to the Base (52) with
six 19mm Tek Screws (26).
1
52
26
26
63
63
63
26
63
26
63
26
M10 Flat
Washer (14)–2
G
M8 x 15mm
Bolt (8)–6
M10 Star
Washer (9)–2
M8 Star
Washer (5)–6
M10 x 58mm Bolt (2)–4
M10 x 110mm Bolt (1)–2
16mm Screw
(85)–2
M5 Star
Washer (7)–2
M8 Nut (46)–2
19mm Screw (10)–4
M8 Flat
Washer (72)–4
U
18mm Screw (58)–2
19mm Tek
Screw (26)–6
M6 Flat
Washer (32)–4
M6 Nut (43)–4
M6 x 58mm Bolt (13)–4
M8 x 52mm Bolt (82)–2
ASSEMBLY
A
ssembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant
o
n top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
In addition to the included hex keys , assembly requires a Phillips screwdriver , an
adjustable wrench , and needlenose pliers . Use the drawings below to identify the hard-
ware used during assembly. Note: If a part is not in the hardware kit, check to see if it has been preattached
to one of the parts to be assembled. Extra hardware may be included. To avoid damaging plastic parts, do
not use power tools for assembly.