Filter
Top Products
10. Set the Console (91) on the Uprights (53, 54).
Make sure that no wires are pinched. Start
four M8 x 15mm Bolts (8) with four M8 Star
Washers (5) into the Uprights as shown. Do not
fully tighten the Bolts yet.
10
8
8
5
5
91
54
53
11. Start an M8 x 15mm Bolt (8) with an M8 Star
Washer (5) into each Upright (53, 54). See
steps 10 and 11. Firmly tighten all six M8 x
15mm Bolts.
With the help of a second person, carefully
lower the Uprights (53, 54) to the floor.
11
8
8
8
5
8
5
54
53
9. Have a second person hold the Console (91) near
t
he Right Upright (54).
Connect the Wire Harness (39) to the console
wire. See the inset drawing. The connectors
s
hould slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Then, insert the connectors and
the excess wire downward into the Right Upright
(54). Remove the wire ties from the Wire
Harness and the console wire.
9
91
54
39
Console Wire
39
10
Console
Wire