8
6. Hold the Console Assembly (91) near the Right Upright
(54). Touch the Right Handrail to discharge any static.
Insert the end of the Wire Harness (98) into the hole in
the bottom of the Right Handrail (55) and out of the large
hole in the side. Next, Insert the end of the Wire Harness
through the two looped plastic ties.
Press the end of the Wire Harness (98) into the indicated
connector on the back of the Console Assembly (91).
The end of the Wire Harness should slide easily into
the connector and snap into place. If it does not, turn
the end of the Wire Harness and try again. IF THE CON-
NECTOR IS NOT INSERTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER IS
TURNED ON.
Plastic
Ties
Connector
91
55
98
54
5. Place the Left Handrail (56) on the Console Assembly
(91). Attach the end of the ground wire from the Console
A
ssembly to the indicated small hole in the Left Handrail
with the Silver Ground Screw (8).
Attach the Left Handrail (56) to the Console Assembly
(91) with two Console Screws (4), a Crossbar Screw (5),
and a Crossbar Star Washer (12).
Be careful not to
pinch the ground wire.
12
91
4
5
56
8
Ground Wire
S
mall
Hole
6
5
98
7. Insert the slack in the Wire Harness (98) down into the
Right Upright (54). Then, tighten the two plastic ties
around the Wire Harness, and cut off the ends of the plas-
tic ties.
98
Plastic
Ties
54
7