Filter
Top Products
ASSEMBLY
Place all parts ofthe stepper in a cleared area and remove the packing materials, Do not dispose of the packing
materials until assembly is completed. Note: Some small parts may have been pre-sttached for shipping. If
a part is not in the parts hag, check to see if it has been pre-attached.
Assembly requires only the included allen wrench.
1. Raise the Stabilizer Frame (23) and the Frame (29)
until they meet. Refer to the inset drawing. Set the
Stabilizer Frame into the saddle on the Frame. Attach
the Stabilizer Frame to the Frame with an M8 Curve
Washer (2} and the Frame Knob (36).
2. While holding the Upright (27) near the Frame (29) as
shown, connect the Reed Switch Wire (34) to the
Upper Wire (37). Attach the Upright to the Frame with
three M8 Curve Washers (2), three M8 Spring
Washers (9), and three M8 x 15ram Screws (3).
23
2
36 2 29
34_
2
4