Filter
Top Products
To make assembly easier, read the information
on page 4 before you begin assembling the
Turn the Front Stabilizer (2) so that the large holes are
facing the Frame (1). Attach the Front Stabilizer to the
Frame with two M10 x 60mm Button Screws (33).
2. Attach the Rear Stabilizer (6) to the Seat Frame (5)
with two M10 x 75mm Carriage Bolts (30) and two
M10 Nylon Locknuts (65).
3. Insert the end of the Seat Frame (5) into the Frame (1).
Next, firmly press the Frame Bushing (56) into the
Frame. Attach the Frame Bushing to the Frame with
two M4 x 5mm Self-tapping Screws (66). Then, tighten
the Adjustment Knob (9) into the Frame.
Carefully tip the exercise cycle onto its side. Attach the
two Bumpers (57) to the Frame (1) with two M4 x 8mm
Screws (29) and two M4 Washers (70). Then, tip the
exercise cycle upright.
Attach the Left and Right Seat Brackets (14, 15) to the
Seat Frame (5) with two M8 x 125mm Bolts (62), four
M8 Washers (54), and two M8 Nylon Locknuts (10) as
shown. Do not tighten the Nylon Locknuts yet.
1
2
33
Large
Holes 1
\
65
54 10
30
54 10