Filter
Top Products
7
5
18
18
16
16
16
16
17
17
6
3. Attach the Crossbars (2, 3) to the Uprights (1)
with four M8 x 65mm Bolts (22), two Support
Plates (12), and four M8 Nylon Locknuts (23). Do
not tighten the Nylon Locknuts yet. Note the
position of the name decal and make sure the
Uprights are oriented as shown.
4. Press a 25.4mm Round Inner Cap (19) into the
indicated end of the Weight Tube (37). Slide the
Weight Tube through the Leg Lever (6) and attach
it with an M8 x 50mm Bolt (35), two M8 Washers
(29), a Sleeve (36), and an M8 Nylon Locknut
(23). Press a 25.4mm Angle Cap (20) onto the
other end of the Weight Tube.
Tap three 38mm Square Inner Caps (14) into the
Leg Lever (6).
Lubricate the M10 x 60mm Bolt (27). Attach the
Leg Lever (6) to the Front Leg (5) with the Bolt
and an M10 Nylon Locknut (30). Do not over-
tighten the Nylon Locknut; the Leg Lever must
be able to pivot freely.
5. Press two 19mm Round Inner Caps (16) into
each Pad Tube (17). Slide the Pad Tubes through
the holes in the Leg Lever (6). Slide a Foam Pad
(18) onto each side of the two Pad Tubes.
4
3
23
12
12
23
2
3
1
22
22
19
37
6
20
5
27
Lubricate
14
14
14
35
29
36
23
29
30
1
Name
Decal