Wenger 543.103 Watch User Manual


  Open as PDF
of 12
 
8
9
Stopwatch
1. To start the stopwatch, push the top pusher.
2. To stop it, push the top pusher again.
3. Read the 1/10th seconds, seconds, and minutes on the appropriate dials.
4. To reset the stopwatch to zero, push the bottom pusher.
Note: The clock function of the watch will continue to operate while using the
stopwatch.
Using the Split-Timing Function
1.Pressthetoppushertostartthestopwatch.
2. To read a lap or other intermediate segment of time, push the bottom pusher.
The watch hands will stop, but the watch will continue to time the total event
internally.
3. To resume timing the total event, push the bottom pusher again.
4. You may repeat this as often as you like. The internal clock will continue to
time the total event each time you repeat the process.
5. To stop timing the total event, push the top pusher.
6. Reset the stopwatch to zero by pushing the bottom pusher.
Recalibrating the Timer Hands on 30-Minute Models
(for Ladies Sport Chronos see p.10)
The timer hands are preset to begin at zero. It is possible that over time the hands
will not begin at zero. If this happens you will need to recalibrate the hands. You
may also set them to begin at a different point (see below).
1.Torecalibratethe30-minutetimer,pullthecrownouttoPosition3(unscrew
thecrownrstifwatchis200m).Pressthebottompusherrepeatedlyuntil
seconds hand is in desired starting position.
2.Torecalibratethesecondshandtimer,pullthecrownouttoPosition2(unscrew
crownrstifwatchis200m).Pressthetoppusherrepeatedlyuntilseconds
hand is in desired starting position.
3.Torecalibratethe1/10-secondtimer,pullthecrownouttoPosition2(unscrew
crownrstifwatchis200m).Pressthetoppusherrepeatedlyuntil1/10-
seconds hand is in desired starting position.
4.ReturncrowntoPosition1whennished,assuringcrownisscreweddownon
200m watches.
 previous next