Filter
Top Products
25
22
23
24
22. Locate the Medium Cable (58). Route the
Medium Cable (58) under the 3 1/2Ó Pulley
(15) attached to the bracket on the Press
Frame (17). Be sure that the end of the
Cable with the ball is on the indicated side
of the Press Frame and that the Cable is
between the Pulley and the crossbar on
the Press Frame.
23. Route the Medium Cable (58) around the
3 1/2Ó Pulley (15) attached to the lower hole
in the Front Upright (42). See the inset draw-
ing. Be sure that the Cable Trap (66) is
turned to hold the Cable in place and that
the Cable is routed around the Pulley as
shown. Tighten the 3/8Ó Nylon Locknut (21)
and the 3/8Ó x 3 3/4Ó Bolt (71).
24. Route the Medium Cable (58) around the
3 1/2Ó Pulley (15) attached to the upper hole
in the Press Frame (17). Be sure that the
Cable Trap (66) is turned to hold the Cable
in place and that the Cable is routed
around the Pulley as shown. Make sure the
3/8Ó Nylon Locknut (21) and the 3/8Ó x 3 1/2Ó
Bolt (not shown) are tight.
25. Route the Medium Cable (58) around the
3 1/2Ó Pulley (15) attached to the upper hole
in the Front Upright (42). See the inset draw-
ing. Be sure that the Cable Trap (66) is
turned to hold the Cable in place and that
the Cable is routed around the Pulley as
shown. Tighten the 3/8Ó Nylon Locknut (21)
and the 3/8Ó x 3 3/4Ó Bolt (71).
12
CABLE ASSEMBLY
17
Ball
15
21
71
58
21
58
21
58
Inset shows view
from other side
15
42
42
58
15
66
66
15
71
58
Inset shows view
from other side
42
66
15
15
17
Crossbar
21
42
58