Filter
Top Products
14
25. Locate the Low Cable (23). Route the Low
Cable under the 3 1/2” Low Pulley (76) attached
to the lower hole in the Press Frame (17). Be
sure that the ball on the Cable is on the indi-
cated side of the Press Frame and that the
Cable is between the Pulley and the crossbar
on the Press Frame. Tighten the 3/8” Nylon
Locknut (21) and the 3/8” x 3 3/4” Bolt (not
shown).
26. Wrap the Low Cable (23) around a 3 1/2” Pulley
(15). Attach the Pulley and a Cable Trap (66) to
the lower hole in the Front Upright (42) with a 3/8”
x 3 3/4” Bolt (88), a 3/8” Washer (9), and a 3/8”
Nylon Locknut (21). See the inset drawing. Be
sure that the Cable Trap (66) is turned to hold
the Cable in place and that the Cable and
Pulley move smoothly.
27. Route the Low Cable (23) around the 3 1/2”
Pulley (15) attached to the upper hole in the
Press Frame (17). Be sure that the Cable Trap
(66) is turned to hold the Cable in place and
that the Cable is routed around the Pulley as
shown. Tighten the 3/8” Nylon Locknut (21) and
the 3/8” x 3 1/2” Bolt (not shown).
28. Wrap the Low Cable (23) around a 3 1/2” Pulley
(15). Attach the Pulley and a Cable Trap (66) to
the upper hole in the Front Upright (42) with a
3/8” x 3 3/4” Bolt (88), a 3/8” Washer (9), and a
3/8” Nylon Locknut (21). See the inset drawing.
Be sure that the Cable Trap is turned to hold
the Cable in place and that the Cable and
Pulley move smoothly.
28
25
23
26
27
21
17
Ball
23
21
15
42
Inset shows view
from other side
42
21
88
9
23
23
15
15
66
66
Inset shows view
from other side
42
21
88
9
23
15
66
66
42
21
23
17
66
15
76
Crossbar
21