Filter
Top Products
14
24. Wrap the Long Cable (72) around a 3 1/2” Pulley
(15). Attach the Pulley and a Cable Trap (66) to
the Squat Arm (84) with the 3/8” x 2 1/4” Bolt (94)
and a 3/8” Jamnut (92). Be sure that the
Jamnut is on the side shown and that the
Cable Trap is positioned to hold the Cable in
place.
24
15
Bracket
84
66
92
94
72
25. See inset drawing A. Note: The inset drawing
shows the view from the other side of the
Squat Upright (56). Wrap the Long Cable (72)
around a “V”-Pulley (50). Attach the Pulley and a
Long Cable Trap (31) to the top hole in the Squat
Upright with the 3/8” x 5” Bolt (67), the 5/8” x 3/8”
Spacer (76), a 3/8” Washer (9), and a 3/8” Nylon
Locknut (21). Position the Long Cable Trap as
shown.
See inset drawing B. Note: The inset drawing
shows the view from the other side of the
Squat Upright (56). Slide the end of the Long
Cable (72) onto the end of the 3/8” x 2 1/4” Bolt
(94). Thread another 3/8” Jamnut (92) onto the
Bolt. Do not tighten the second Jamnut; there
must be room between the two Jamnuts for
the end of the Cable to pivot.
25
67
31
50
50
A
B
76
9
72
92
94
72
72
Insets show view
from other side
56
56
21
26. Attach the Backrest (41) to the Front Upright (42)
with two 1/4” x 2 1/2” Screws (43) and two 1/4”
Washers (10).
26
SEAT ASSEMBLY
42
41
43
10