Filter
Top Products
17
ATTACHING AND REMOVING THE SEAT
Set the bracket on the Seat Frame (36) on the indicated
pin on the Front Upright (42). Attach the Seat Frame to
the Front Upright with the 5/16Ó x 2 3/4Ó Carriage Bolt
(14) and Seat Knob (40).
For some exercises, the Seat (13) must be removed.
First, make sure that the chain is not attached to the leg
lever. Next, remove the Seat Knob (40) and 5/16Ó x 2
3/4Ó Carriage Bolt (14) from the Seat Frame (36). Lift
the Seat Frame off the Front Upright (42).
ATTACHING THE LEG LEVER TO THE LOW
PULLEY STATION
To use the Leg Lever (29), the seat must be attached to
the front upright (see ATTACHING AND REMOVING
THE SEAT on page 13). Attach the Chain (84) between
the Short Cable (23) and the 5/16Ó x 2Ó Eyebolt (35) on
the Leg Lever with two Cable Clips (83).
ATTACHING THE LAT BAR OR NYLON STRAP TO
THE HIGH PULLEY STATION
Attach the Lat Bar (85) to the Long Cable (66) with a
Cable Clip (83). For some exercises, the Chain (84)
should be attached between the Lat Bar and the Long
Cable with two Cable Clips. Adjust the length of the
Chain between the Lat Bar and the Long Cable so
the Lat Bar is in the correct starting position for the
exercise to be performed.
The Nylon Strap (39) can be attached in the same man-
ner.
39
66
83
84
85
84
23
62
29
14
40
36
42
Pin
83