Filter
Top Products
15
31. Press two 3/4Ó Round Inner Caps (34) into each Pad
Tube (28).
Insert one Pad Tube into the Seat Frame (36). Slide a
Foam Pad (30) onto each end of the Pad Tube.
Insert the other Pad Tube into the Leg Lever (29).
Slide a Foam Pad (30) onto each end of the Pad
Tube.
31
30
28
30
34
36
29
34
Miscellaneous Assembly
32. Attach the Curl Pad (24) to the Curl Post (10) with
two 1/4Ó x 1/2Ó Screws (17).
Slide the Curl Post (10) onto the Seat Frame (36) so
each of the welded brackets are between the Seat
Frame and the bracket on the Leg lever (29). Secure
the Curl Post with the 5/16Ó x 2Ó Knob (72).
Make sure the Leg Lever (29) can be turned freely
after the Curl Post (10) is mounted.
32
17
36
29
10
72
24
33. Align the Left Shroud (78) with the holes in the Top
Frame (1), Base (8) and the two Uprights (18, 42)
and attach it with 14 of the #8 x 1/2Ó Tap Screws (7).
Move to the other side of the unit and attach the
Right Shroud (79) which is the one with the opening
for adjusting the Weights. Align the Right Shroud with
the holes in the Top Frame (1), Base (8) and the two
Uprights (18, 42) and attach it with 14 of the #8 x 1/2Ó
Tap Screws (7).
33
42
7
7
7
7
7
7
79
18
Welded
Brackets
78
1
8
34. Make sure that all parts have been properly tight-
ened. The use of the remaining parts will be
explained in ADJUSTMENT, beginning on page 17
of this manual.
Before using the home gym system, pull each
cable a few times to be sure that the cables move
smoothly over the pulleys. If one of the cables does
not move smoothly, find and correct the problem.
IMPORTANT: If the cables are not properly
installed, they may be damaged when heavy
weight is used. If there is any slack in the
cables, you will need to remove the slack by
tightening the cables. See TROUBLE-SHOOT-
ING AND MAINTENANCE on page 19.