Filter
Top Products
15
29. Attach the end of the Low Cable (23) to the Long
“U”-Bracket (57) with a 1/4” Nylon Locknut (2) and a
1/4” Washer (10). Do not completely tighten the
Nylon Locknut. It should be threaded onto the
end of the Cable so only a couple of threads are
showing above the Nylon Locknut, as shown in
the inset drawing.
You may need to lift the Top Weight (not shown)
on the High Cable (58) to get enough slack to
attach the Low Cable (23) to the Long “U”-
Bracket (57).
30. Locate the Military Press Cable (72). Attach the
Military Press Cable to the other Small “U”-Bracket
(71) with a 1/4” Nylon Locknut (2) and a 1/4”
Washer (10). Do not completely tighten the Nylon
Locknut; it should be threaded onto the end of
the Cable only a couple of turns, as shown in
the inset drawing.
Attach the Small “U”-Bracket (71) to the indicated
Weight Tube (63) with a 5/16” x 1 3/4” Bolt (24) and
a 5/16” Nylon Locknut (3).
31. Wrap the Military Press Cable (72) around a 3 1/2”
Pulley (15). Attach the Pulley to the Top Frame (55)
with a 3/8” x 2” Bolt (12) and a 3/8” Nylon Locknut
(21).
See the inset drawing. Wrap the Military Press
Cable (72) around a 3 1/2” Pulley (15). Attach the
Pulley and a Cable Trap (66) to the bracket on the
Stabilizer (5) with a 3/8” x 2” Bolt (12) and a 3/8”
Nylon Locknut (21). Be sure that the Cable Trap
is turned to hold the Cable in place.
30
29
10
57
58
23
24
63
71
10
2
3
72
2
2
10
57
23
72
10
2
71
31
5
Bracket
66
12
72
15
15
21
21
55
12
72