Weider WESY39310 Home Gym User Manual


 
10
12. Press a 1” Round Inner Cap (49) into one of the
Press Arms (46). Press a 1 3/4” Square Inner Cap
(44) into the Press Arm.
Attach the Press Arm (46) to one side of the Press
Frame (17) with two 5/16” x 2 1/2” Bolts (22) and
two 5/16” Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same
manner.
13. Identify the Right Arm (48) and the Left Arm (47).
Note the position of the welded bracket on each
Arm. Arm identification is very important for
step 14.
Attach a “V”-Pulley (50) and a Long Cable Trap (31)
to the Right Arm (48) with a 3/8” x 2 1/2” Bolt (86)
and a 3/8” Nylon Locknut (21). Do not tighten the
Nylon Locknut yet.
Attach a “V”-Pulley (50) and a Long Cable Trap (31)
to the Left Arm (47) in the same manner.
14. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle on the
Top Frame (55). Note: Be careful not to confuse
the Right Arm with the Left Arm (47); refer to
step 13 to identify the Right Arm. Be sure that
the upper end of the Right Arm is behind the
indicated bracket on the Top Frame.
See the inset drawing. Tap two 1” Retainers (69)
and a 1” Round Cover Cap (70) onto the axle. Be
sure that the teeth on the Retainers bend
toward the Round Cover Cap, as shown.
Attach the Left Arm (47) in the same manner.
Press 1 3/4” Square Inner Caps (44) into the lower
ends of the Right and Left Arms (47, 48). Wet the
lower end of each Arm with soapy water. Slide a
10” Pad (45) onto the lower end of each Arm.
12
13
86
31
31
50
50
21
Welded
Brackets
48
47
44
49
46
46
17
22
3
55
Bracket
Lubricate
Axle
47
69
70
44
45
44
14
69
70
Axle
45
48