Filter
Top Products
14
25. Locate the Low Cable (23) and the bag labeled
“LOW PULLEY.” Route the Low Cable under the
3 1/2” Low Pulley (76). Attach the Pulley and the
5/8” x 9/16” Spacer (7) to the Press Frame (17) with
a 3/8” x 3 3/4” Bolt (88), 3/8” Washer (9), and a 3/8”
Nylon Locknut (21). Be sure that the parts are ori-
ented as shown in the drawing, and that the end
of the Cable with the ball is on the indicated
side of the Press Frame, between the Pulley and
the crossbar.
26. Route the Low Cable (23) around a 3 1/2” Pulley
(15). Attach Pulley and a Cable Trap (66) to the
lower hole in the Front Upright (42) with a 3/8” x
3 3/4” Bolt (88), a 3/8” Washer (9), and a 3/8” Nylon
Locknut (21). See the inset drawing. Be sure that
the Cable Trap is turned to hold the Cable in
place and that the Cable is routed around the
Pulley as shown.
27. Route the Low Cable (23) around a 3 1/2” Pulley
(15). Attach the Pulley and a Cable Trap (66) to the
upper hole in the Press Frame (17) with a 3/8” x
3 1/2” Bolt (16), a 3/8” Washer (9), and a 3/8” Nylon
Locknut (21). Be sure that the Cable Trap is
turned to hold the Cable in place and that the
Cable is routed around the Pulley as shown.
28. Route the Low Cable (23) around another 3 1/2”
Pulley (15). Attach the Pulley and a Cable Trap (66)
to the upper hole in the Front Upright (42) with a
3/8” x 3 3/4” Bolt (88), a 3/8” Washer (9), and a 3/8”
Nylon Locknut (21). See the inset drawing. Be
sure that the Cable Trap is turned to hold the
Cable in place and that the Cable is routed
around the Pulley as shown.
28
27
Inset shows view
from other side
42
88
23
23
15
15
66
42
21
88
9
66
23
17
66
15
9
16
21
21
17
76
7
9
88
23
17
Ball
76
Crossbar
23
88
9
15
42
26
Inset shows view
from other side
42
21
23
15
66
66
21
25