Filter
Top Products
12
19. Slide four Foam Pads (32) onto the Pad Tube
(35) and the Leg Lever (9). Press a 19mm
Round Inner Cap (33) into each Foam Pad.
20. Set the Seat Frame (8) onto the Upright Base
(5) as shown.
21. Make sure that all parts have been properly
tightened.
The use of the remaining parts will be
explained in ADJUSTMENTS, beginning on the
next page.
32
19
20
32
32
33
33
33
32
9
35
8
5
17. Attach the Seat (31) and the Seat Plate (84) to
the Seat Frame (8) with two M6 x 87mm
S
crews (73) and two M6 Washers (60).
A
ttach the Bumper (36) to the Seat Frame (8)
with an M4 x 16mm Screw (61).
Slide the Pad Tube (35) into the Seat Frame
(8).
18. Grease the barrel of an M10 x 51mm Bolt Set
(75). Attach the Leg Lever (9) with the Bolt Set.
Do not overtighten the Bolt Set; the Leg
Lever must be able to pivot easily.
Wide End
8
61
36
73
17
18
31
35
84
8
9
75
Grease
75
60