Filter
Top Products
31. Attach the Seat (13) to the Seat Frame (36)
using two 1/4” x 3/4” Bolts (18), a 1/4” x 2 1/4”
Bolt (33), and a 1/4” Flat Washer (78).
32. Attach the Backrest (41) to the Front Upright
(42) using two 1/4” x 3” Bolts (43) and two
1/4” Flat Washers (78).
33. Insert 3/4” Round Inner Caps (34) into both
end of two Pad Tubes (28). Slide the Pad
Tubes into the holes in the Leg Lever (29)
and the Seat Frame (36). Slide Foam Pads
(30) onto both ends of the Pad Tubes.
34. Attach the Curl Pad (24) to the Curl Post (35)
with two 1/4” x 3/4” Bolts (18).
To attach the Curl Post (35) to the training
system, remove the 1 1/2” Square Inner Cap
(32) from the Seat Frame (36). Insert the Curl
Post into the Seat Frame and tighten the
Knob (51) into the Seat Frame and the Curl
Post.
Note: When the Curl Post (35) is not in
use, replace the 1 1/2” Square Inner Cap
(32).
16
SEAT ASSEMBLY
31
13
18
32
41
78
78
42
43
43
33
30
30
30
28
29
36
34
34
34
24
35
18
51
36
32
33
78
36