Filter
Top Products
7
4
4
Tube
Welded
Spacers
17
59
Lubricate
21
9
9
3. Press a 45mm Square Inner Cap (44) into each
end of the crossbar on the Top Frame (55). Press
two 25mm Round Inner Caps (49) into the top of
the crossbar. Press a 50mm Square Inner Cap
(27) into the top of the Rear Upright (56).
Attach the Top Frame (55) to the Front Upright
(42) with a Support Plate (68), two M8 x 67mm
Bolts (61), and two M8 Nylon Locknuts (3). Attach
the Top Frame to the Rear Upright (56) with the
other Support Plate, two M8 x 67mm Bolts (61),
and two M8 Nylon Locknuts (3).
Tighten the Nylon Locknuts used in steps 1–3.
4. Press a 25mm Plastic Bushing (26) onto each
welded spacer on the Press Frame (17). Orient
the Press Frame so the indicated hole is on the
side shown. Slide the Press Frame onto the Base
(4) so the Plastic Bushings are aligned with the
indicated tube. Note: This will be a tight fit. The
Plastic Bushings should fit onto the ends of
the welded tube in the Base.
Lubricate an M10 x 198mm Bolt (59). Attach the
Press Frame (17) to the Base (4) with the Bolt, two
M10 Washers (9), and an M10 Nylon Locknut (21).
ARM ASSEMBLY
3
61
61
44
44
49
27
55
68
68
56
42
3
Crossbar
3
26
5. Press a 45mm Square Inner Cap (44) into the top
of one of the Press Arms (46). Press a 25mm
Round Inner Cap (49) into each end of the handle
on the Press Arm. Attach the Press Arm to one
side of the Press Frame (17) with two M8 x
63mm Bolts (22) and two M8 Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same
manner.
6. Identify the Left Arm (47) and the Right Arm (48).
Note the position of the welded bracket on each
Arm. Arm identification is very important for
step 7.
Press a Butterfly Arm Bushing (60) into each Arm
(47, 48).
46
3
22
46
49
49
44
17
44
49
5
48
60
60
47
Welded
Brackets
6
Hole