Filter
Top Products
23. Attach the Backrest (41) to the Front Upright (42)
with two M6 x 63mm Screws (43) and two M6
Washers (10).
SEAT ASSEMBLY
23
41
42
10
43
13
24. Press a 38mm Square Inner Cap (32) into the
Seat Frame (36).
Insert an M6 x 50mm Carriage Bolt (38) into the
center hole in the Seat Plate (37). Attach the Seat
Plate to the Seat (13) with two M6 x 16mm
Screws (18).
Insert the M6 x 50mm Carriage Bolt (38) into the
indicated hole in the Seat Frame (36). Tighten an
M6 Nylon Locknut (2) with an M6 Washer (10)
onto the Carriage Bolt.
Attach the other end of the Seat (13) to the Seat
Frame (36) with an M6 Washer (10) and the M6 x
50mm Screw (24).
25. Press a 38mm Square Inner Cap (32) into the
Leg Lever (29).
Lubricate the M8 x 67mm Bolt (61). Attach the
Leg Lever (29) to the Seat Frame (36) with the
Bolt and an M8 Nylon Locknut (3). Do not over-
tighten the Nylon Locknut; the Leg Lever
must pivot freely.
Insert the two M10 Eyebolts (35) into the Leg
Lever (29) from the directions shown. Tighten an
M10 Washer (9) and an M10 Nylon Locknut (21)
onto each Eyebolt. Note: Be sure the Eyebolts
are positioned vertically on the Leg Lever.
24
25
10
2
24
36
36
3
Lubricate
29
9
9
21
21
32
35
35
61
13
38
37
32
18