Filter
Top Products
7
ARM ASSEMBLY
5. Press a 1 3/4” Square Inner Cap (44) into the
top of one of the Press Arms (46). Press a 1”
Round Inner Cap (49) into each end of the
handle on the Press Arm. Attach the Press
Arm to one side of the Press Frame (17) with
two 5/16” x 2 1/2” Bolts (22) and two 5/16”
Nylon Locknuts (3).
Assemble the other Press Arm (46) in the
same manner.
6. Identify the Right Arm (48) and the Left Arm
(47). Note the position of the welded bracket
on each Arm. Arm identification is very
important for step 7.
7. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right
Arm with the Left Arm (47); refer to step 6
to identify the Right Arm. Be sure that the
upper end of the Right Arm is behind the
indicated bracket on the Top Frame (55).
Tap two 1” Retainers (63) and a 1” Round
Cover Cap (62) onto the right axle. Be sure
that the teeth on the Retainers bend
toward the Cover Cap, as shown in the
inset drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4” Square Inner Caps (44) into the
lower ends of the Right and Left Arms (47,
48). Wet the lower end of each Arm with
soapy water. Slide a Foam Pad (45) onto the
lower end of each Arm.
46
3
22
46
49
49
44
17
44
49
5
48
47
Welded
Brackets
6
7
Bracket
Lubricate
Axle
45
47
55
48
45
44
63
62
63
55
62