Filter
Top Products
6
2. Press a 50mm Square Inner Cap (44) into the top
of the Rear Upright (3).
Attach the Rear Upright (3) to the Stabilizer (2)
with the M8 x 67mm Carriage Bolts (66) and two
M8 Nylon Locknuts (61).
Attach the Front Upright (4) to the Base (1) with
the two M8 x 63mm Carriage Bolts (65) and two
M8 Nylon Locknuts (61).
Do not tighten the M8 Nylon Locknuts (61) yet.
Press a 25mm x 50mm Inner Cap (42) into the
tube on the Front Upright (4). Attach the Arm
Latch (29) to the Front Upright with an M8 x
63mm Bolt (78), two M8 Washers (76), and an
M8 Nylon Locknut (61). Do not overtighten the
Nylon Locknut; the Arm Latch must be able to
pivot easily.
2
3
4
1
60
25
4
3
61
72
43
26
75
61
52
51
52
52
43
3
27
5
61
78
76
42
76
61
4
44
65
66
29
61
3
61
2
4. Attach the Top Frame (5) to the Front Upright (4)
with two M8 x 68mm Bolts (72) and two M8 Nylon
Locknuts (61).
Attach the Top Frame (5) to the Rear Upright (3)
with two M8 x 66mm Bolts (60), the Support Plate
(25), and an M8 Nylon Locknut (61).
Tighten all of the M8 Nylon Locknuts (61)
used in steps 2 and 4.
3. Press two 25mm Round Inner Caps (43) into the
ends of the tube on the Weight Carriage (26).
Insert the M10 x 20mm Bolt (75) into the bracket
on the Weight Carriage from the side shown.
Make sure there are three Square Bushings (52)
inside the Weight Carriage and the top of the
Weight Stop (27).
Slide the Weight Stop (27) onto the Rear Upright
(3) and secure it with an M8 x 70mm Bolt (51)
and an M8 Nylon Locknut (61).
Slide the Weight Carriage (26) onto the Rear
Upright (3).