Filter
Top Products
34. Make sure that all parts have been properly tightened. The use of all remaining parts will be explained in
ADJUSTMENTS, on the next page.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If
the cables are not properly routed, they may be damaged when heavy weight is used. See the CABLE
DIAGRAM on page 18 of this manual for proper cable routing. If there is any slack in the cables, you
will need to remove it by tightening the cables; see TROUBLESHOOTING AND MAINTENANCE on
page 19.
14
32. Attach the Curl Pad (18) to the Curl Post (8) with
two M6 x 16mm Screws (59).
33. Wet the ends of the Lat Bar (12) with soapy
water. Slide the two Lat Bar Grips (33) onto the
ends of the Lat Bar.
31. Slide a Pad Tube (21) through the hole in the
Seat Frame (6). Slide two Small Foam Pads (20)
onto the ends of the Pad Tube. Press two 19mm
Round Inner Caps (49) into the ends of the Pad
Tube.
Repeat this step with the other Pad Tube (21)
and the Leg Lever (7).
49
49
20
21
6
20
7
18
21
59
8
31
32
33
33
12
33