Filter
Top Products
11
20. Attach the Short Cable (80) to the “U”-Bracket
(81) with an M8 Washer (76) and an M8 Nylon
Locknut (61). Note: Do not completely tighten
the Locknut; it should be threaded only two
turns onto the end of the Cable, as shown in
the inset drawing.
19. Wrap the Short Cable (80) around a Pulley (39).
Attach the Pulley to the Double “U”-Bracket (15)
with an M10 x 45mm Bolt (68) and an M10 Nylon
Locknut (56).
80
15
56
68
39
19
80
81
76
61
20
80
61
21. Locate the Low Cable (37). Lay the Cable in the
bracket on the Base (1) with the ball on the side
shown.
Attach a Pulley (39) inside the bracket on the
Base (1) with an M10 x 45mm Bolt (68) and an
M10 Nylon Locknut (56).
68
39
37
56
1
21
22. Route the Low Cable (37) through the hole in the
Front Upright (4) and around a Pulley (39). Attach
the Pulley and a Cable Trap (41) inside the brack-
et on the Upright with an M10 x 48mm Bolt (77)
and an M10 Nylon Locknut (56). Be sure the
Cable Trap is oriented to hold the Cable in the
groove of the Pulley.
77
41
56
39 4
37
22