Filter
Top Products
9
10. Route the Short Cable (58) around the 90mm
Pulley (15). Tighten the M10 x 80mm Bolt (16),
the M10 W
asher (9), and the M10 Nylon Locknut
(21).
11. Route the Short Cable (58) under a 90mm Pulley
(15). Attach the Pulley and a Cable Trap (66) to
the upper hole in the Front Upright (42) with an
M10 x 95mm Bolt (71), an M10 Washer (9), and
an M10 Nylon Locknut (21).
Make sure that the
Cable Trap is turned to hold the Cable in the
groove of the Pulley.
12. Attach the end of the Short Cable (58) to the
Long “U”-bracket (57) with an M8 Nylon Locknut
(3) and an M8 Washer (8). See the inset draw-
ing. Do not overtighten the Locknut; it should
be threaded onto the end of the Cable so that
two threads are showing above the nut.
13. Locate the Long Cable (23). Route the Long
Cable over a 90mm Pulley (15). Make sure that
the Cable is between the Pulley and the hook
and that the end of the Cable with the ball is
on the indicated side of the hook.
Tighten the
M10 x 90mm Bolt (85) and the M10 Nylon
Locknut (21).
13
10
11
12
57
23
15
Hook
Ball
85
21
58
55
21
15
58
17
9
16
3
8
21
58
42
15
66
71
9
58
57
3
8