Filter
Top Products
12
21. Insert the M6 x 50mm Carriage Bolt (38) into the
center hole in the Seat Plate (37). Attach the Seat
Plate to the Seat (13) with two M6 x 16mm
Screws (18).
Insert the M6 x 50mm Carriage Bolt (38) into the
indicated hole in the Seat Frame (36). Tighten an
M6 Nylon Locknut (2) with an M6 Washer (10)
onto the Carriage Bolt.
Attach the other end of the Seat (13) to the Seat
Frame (36) with an M6 Washer (10) and an M6 x
50mm Screw (24).
22. Lubricate the M8 x 57mm Bolt (80) with grease.
Attach the Leg Lever (29) to the Seat Frame (36)
with the Bolt and an M8 Nylon Locknut (3).
Make
sure the decal is in the indicated position. Do
not overtighten the Locknut; the Leg Lever
must be able to pivot freely.
Insert a Eyebolt (35) into the Leg Lever (29) from
the direction shown. Tighten an M10 Nylon
Locknut (21) and an M10 Washer (9) onto the
Eyebolt.
23. Insert a Pad Tube (28) into the Seat Frame (36).
Wet the Pad Tube with soapy water. Slide two
Small Pads (30) onto the Pad Tube.
Assemble the other Pad Tube (28) to the Leg
Lever (29) in the same manner.
24. Rest the Seat Frame (36) on the indicated pin in
the Front Upright (42). Attach the Seat Frame to
the Front Upright with an M8 x 67mm Carriage
Bolt (86) and the Seat Knob (40).
21
80
Lubricate
Decal
35
21
9
29
22
3
36
23
24
30
30
29
28
28
36
10
2
24
36
13
38
37
18
36
40
Pin
42
86