Filter
Top Products
6
2. Slide the Front Upright (42) onto the M8 x 65mm
Carriage Bolts (1) in the Base (4). Hand tighten
two M8 Nylon Locknuts (3) onto the Carriage
Bolts.
Do not tighten the Locknuts yet.
3. Attach the two Weight Guides (62) inside of the
Stabilizer (5) with two M10 x 67mm Bolts (11),
two M10 Washers (9), two 13mm Spacers (61),
and two M10 Nylon Locknuts (21).
Tighten the M10 Nylon Locknuts (21) used in
step 1.
Slide two Weight Bumpers (19) onto Weight
Guides (62). Stack the six W
eights (25) on the
Weight Bumpers (19). Make sure that all of the
Weights are turned so the large pin grooves
are on the bottom of the Weights and on the
same side of the weight stack.
Press the Weight Tube Bumper (64) into the end
of the Weight Tube (63). Insert the Weight Tube
into the stack of W
eights (25).
Make sure that
the pins on the W
eight T
ube are resting in the
pin grooves in the upper W
eight.
Lubricate the insides of the holes in the
T
op
W
eight (76). Slide the
T
op W
eight onto the
Weight Guides (62).
2
3
42
3
1
4
62
76
21
61
9
9
11
64
63
25
Pin
Groove
19
5
Lubricate
Pin
Groove
Pin