Filter
Top Products
8
FRAME ASSEMBLYARM ASSEMBLY
9. Press the Weight Tube Bumper (64) into the
end of the Weight Tube (63). Insert the
Weight Tube into the stack of Weights (25).
Be sure that the pins on the Weight Tube
are sitting in the pin grooves in the top
Weight.
Lubricate the insides of the holes in the Top
Weight (76). Set the Top Weight onto the
stack of Weights (25). Insert both Weight
Guides (62) into the stack of Weights. Be
sure that the holes in the Weight Guides
are at the top, as shown.
10. Attach the upper ends of the Weight Guides
(62) to the Top Frame (55) with the 5/16” x 6”
Bolt (60), two 1/2” x 3/4” Spacers (61), and a
5/16” Nylon Locknut (3).
Be sure that the Pulley Bracket (20) is in
front of the right Weight Guide (62) as
shown.
11. Press a 1” x 7/8” Plastic Bushing (75) onto
each welded spacer on the Press Frame (17).
Slide the Press Frame into place on the Base
(4). Note: This will be a tight fit. The
Plastic Bushings should fit onto each end
of the indicated tube in the Base. Be sure
that the Pulleys (15) are on the indicated
side.
Lubricate the 3/8” x 8” Bolt (59). Attach the
Press Frame (17) to the Base (4) with the
3/8” x 8” Bolt and a 3/8” Nylon Locknut (21).
11
9
10
55
76
Lubricate
63
Pin
64
25
62
60
20
62
3
4—Tube
Welded
Spacers
17
15
59
Lubricate
21
75
61
Holes