Filter
Top Products
10
CABLE ASSEMBLY
As you assemble the cables and pulleys in
steps 14 through 22, please refer to the
CABLE DIAGRAM on page 22 of this manual.
14. Route the Long Cable (23) around the 3 1/2”
Pulley (15) attached to the Top Frame (55).
Be sure that the end of the Cable with the
ball is on the indicated side of the Pulley
and that the Cable is between the Pulley
and the hook on the Top Frame. Tighten the
3/8” x 3 3/4” Bolt (71) and the 3/8” Nylon
Locknut (not shown).
15. Wrap the Long Cable (23) around a “V”-Pulley
(6). Attach the “V”-Pulley and a Long Cable
Trap (50) to the indicated bracket on the
Front Upright (42) with a 3/8” x 2 1/2” Bolt (7)
and a 3/8” Nylon Locknut (21).
Route the Long Cable (23) around the “V”-
Pulley (6) on the Left Arm (47). Tighten the
3/8” x 2 1/2” Bolt (7) and the 3/8” Nylon
Locknut (not shown). Be sure that the Cable
is in the groove of the Pulley and that the
Long Cable Trap (50) is turned to hold the
Cable in place.
7
7
50
50
6
6
47
21
15
23
14
23
55
15
71
Ball
Hook
42—Bracket