Filter
Top Products
8
7. Press two 25mm Square Inner Caps (12) into
each Backrest Tube (5).
With the help of a second person, slide the indi-
cated ends of the Backrest
Tubes (5) onto the
welded axle on the Frame (2), as shown. Attach
each Backrest Tube to the Backrest (6) with two
M6 x 38mm Screws (16) and two M6 Washers
(25). Do not tighten the four Screws yet.
8. Lift the Backrest (6) and insert the end of the
Support Rod (7) without the locking clip through
the Uprights (1). Rotate the locking clip into place
around the right Upright. Rest the Backrest on the
Support Rod.
When moving the Support Rod (7), always
make sure that the locking clip is in place
around the right Upright (1).
Tighten the four M6 x 38mm Screws (16) used
in step 7, and the M8 Nylon Locknuts (13) used
in step 1.
9. Attach the Seat (11) to the brackets on the Frame
(2) with four M6 x 16mm Screws (15).
16
25
5
12
2
Welded
Axle
6
7
1
1
6
7
8
2
11
15
9
12
25
25
16
16
10. Make sure that all parts are properly tightened before you use the weight bench. The use of all
remaining parts will be explained in ADJUSTMENTS, beginning on the next page.