Filter
Top Products
10
13. Press a Carriage Bushing (23) into each end of the
Weight Carriage (47). Press a Carriage Bushing into
the Carriage Stop (24).
Press a 48mm Round Inner Cap (54) into each
weight tube on the Weight Carriage (47).
Attach the closed loop on the Cable (35) to the brack-
et on the Weight Carriage (47) with an M10 x 19mm
Bolt (56) and an M10 Nylon Locknut (11).
15. Locate the two Front Uprights (1) and identify the
lower end by looking at the group of five holes with
the smallest space between them.
Place the lower end of one Front Upright (1) over the
bracket on the Left Base (2) and secure it with two
M10 x 78mm Bolts (33), four M10 Washers (6) and
two M10 Nylon Locknuts (11). Note: Do not tighten
the Nylon Locknuts yet.
Place the lower end of the other Front Upright (1)
over the bracket on the Right Base (7) and secure it
with two M10 x 78mm Bolts (33), four M10 Washers
(6) and two M10 Nylon Locknuts (11). Note: Do not
tighten the Nylon Locknuts yet.
23
24
54
56
23
1
11
11
6
6
6
6
33
33
2
7
6
6
1
Holes
Holes
35
11
54
47
23
13
14. Slide the Carriage Stop (24) onto the Right Rear
Upright (68) and secure it with an M8 x 86mm Bolt
(58) and an M8 Nylon Locknut (34).
Slide the Weight Carriage (47) onto the Right Rear
Upright (68).
68
47
58
34
24
14
15