Filter
Top Products
13
22. Press a 25mm Round Inner Cap (32) into the end of
each Small Weight Rest (26). Insert the Small Weight
Rests into one set of holes in the Uprights and turn
them, so the locking clips snap into place around the
Uprights.
Insert the Weight Rests (21) into the appropriate
holes in the Uprights and turn them, so the locking
clips snap into place around the Uprights.
22
21
21
26
32
26
32
21. Wrap the Cable (35) around a 3 1/2Ó Pulley (57) in the
direction shown. Attach the Pulley and two Pulley
Covers (31) to the indicated hole in the Right Top
Frame (29) with an M10 x 123mm Bolt (43), a Pulley
Spacer (49), two M10 Washers (6) and an M10 Nylon
Locknut (11).
21
29
43
6
49
35
31
6
31
11
57
20. Slide a Pulley Spacer (49) onto the welded bolt on
the Right Top Frame (29).
Wrap the Cable (35) around a 3 1/2Ó Pulley (57) in
the direction shown. Attach the Pulley and two Pulley
Covers (31) to the welded bolt on the Right Top
Frame (29) with an M10 Washer (6) and an M10
Nylon Locknut (11). The Pulley Covers must be ori-
ented as shown in the inset drawing. Note that
the wide tab is over the stress-point, where the
Cable wraps around the Pulley. Use this orienta-
tion of the Pulley Covers in the following assem-
bly step as well.
20
29
49
35
Welded
Bolt
57
11
6
31
Wide Tab
31
57
Stress-point
on Cable