Filter
Top Products
10
14
14. Press Carriage Bushings (2) onto the top and bottom
of the Weight Carriage (47). Press a 1” Round Inner
Cap (12) into the weight tube on the Weight Carriage.
Insert the M10 x 19mm Bolt (46) into the bracket on
the Weight Carriage (47) from the indicated direction.
Press the last Carriage Bushing (2) into the Carriage
Stop (24) as shown.
2
46
2
24
2
47
12
Weight
Tube
Bracket
12. Press two 3/4” Round Inner Caps (54) into each of
the three Pad Tubes (38).
Slide a Foam Pad (10) onto one end of each Pad
Tube (38).
Insert the free end of each Pad Tube (38) into the
indicated holes in the Leg Lever (18) and the bracket
on the Front Leg (19). Secure each Pad Tube by slid-
ing another Foam Pad (10) onto the free end.
12
54
38
54
10
54
10
54
10
19
38
18
38
10
54
13. Locate the Cable (45) and note that it has a loop on
one end and a ball on the other end. Insert the end
with the loop through the slot in the Lat Tower (9)
from the direction shown. Make sure the Cable is
routed through the bracket exactly as shown.
Next, lay the Cable (45) in the groove of the Pulley
(35). Attach the Pulley inside the slot in the Lat Tower
(9) with the M10 x 68mm Bolt (34), two M10 Washers
(6), two Pulley Spacers (41), and an M10 Nylon
Locknut (11).
Press a 2” Square Inner Cap (17) into the top of the
Lat Tower (9).
13
41
6
9
11
35
6
Bracket
41
17
45
34