Filter
Top Products
9
12. Attach the left side of the Front Crossbar (43) to
the Base (42) with two M10 x 94mm Bolts (18), a
Large Joint Plate (41), and two M10 Nylon
Locknuts (32).
Make sure the Joint Plate is ori-
ented as shown. Do not tighten the Locknuts
yet.
Note: The Base (42) with the warning decal
applied to it should be attached on the right
side of the weight rack (see WARNING DECAL
PLACEMENT on page 2).
Attach the Front Crossbar (43) to the other
Base (not shown) in the same manner.
14. Press a 60mm Square Inner Cap (62) into the Lat
Tower (48).
Orient the Weight Carriage (50) as shown and
slide it onto the Lat
T
ower (48). Orient the
Carriage Stop (52) as shown and slide it onto the
Lat Tower below the Weight Carriage.
Slide the Lat
T
ower (48) onto the Lat
T
ower Base
(49). Attach the Carriage Stop (52) at the indicat-
ed hole with an M10 x 86mm Bolt (35) and an
M10 Nylon Locknut (32).
Secure the Lat Tower (48) to the Lat Tower Base
(49) with three M10 x 72mm Bolts (33), three
M10 Washers (74), and three M10 Nylon
Locknuts (32).
Do not tighten the Locknuts yet.
13. Press a 60mm Square Inner Cap (62) into the
back of the Lat Tower Base (49).
Attach the Lat Tower Base (49) to the Front
Crossbar (43) with two M10 x 68mm Bolts (26)
and two M10 Nylon Locknuts (32).
Do not tight-
en the Locknuts yet.
12
13
14
32
These holes
are closer
to this side
of the Plate.
32
43
42
41
18
18
49
43
48
Attach the
Carriage Stop
(52) here.
32
32
32
49
33
33
74
50
35
52
62
62
26
32