Filter
Top Products
12
20. Route the Cable (79) up through the Lat Tower
(48) and over an 89mm Pulley (65). Attach the
Pulley inside of the Lat
Tower with an M10 x
75mm Bolt (30), two M10 Washers (74), two Long
Spacers (67), and an M10 Nylon Locknut (32).
Make sure the large ball on the Cable is in the
indicated position.
22. Wrap the Cable (79) under an 89mm Pulley (65).
Attach the Pulley and a Cable Trap (64) to the
Weight Carriage (50) with an M10 x 45mm Bolt
(27) and an M10 Nylon Locknut (32). Make sure
the Cable Trap is outside the bracket and ori-
ented to hold the Cable in the groove of the
Pulley.
21. Wrap the Cable (79) over an 89mm Pulley (65).
Attach the Pulley and a Cable Trap (64) to the
bracket on the Lat Tower (48) with an M10 x
75mm Bolt (30).
Make sure the Cable Trap is
inside the bracket and is oriented to hold the
Cable in the groove of the Pulley.
Note: Do not put an M10 Nylon Locknut (not
shown) on the M10 x 75mm Bolt (30) yet.
20
21
23. Wrap the Cable (79) over an 89mm Pulley (65).
Attach the Pulley and a Cable
T
rap (64) to the
bracket on the Lat Tower (48) with the M10 x
75mm Bolt (30) used in step 21 and an M10
Nylon Locknut (32).
Make sure the Cable T
rap
is oriented to hold the Cable in the groove of
the Pulley.
23
22
Large
Ball
79
30
48
32
67
74
65
74
67
79
65
64
30
79
65
32
64
30
48
79
50
27
64
32
65
48