Filter
Top Products
8
7. Press four 1Ó Square Inner Caps (12) into the
indicated ends of the Backrest Tubes (5, 55).
Press two 1Ó x 2Ó Inner Caps (45) into the ends of
the adjustment tubes.
With the wide end of the Backrest (6) positioned
as shown, attach the Backrest Tubes (5, 55) to
the Backrest (6) with four M6 x 38mm Screws
(16) and four M6 Washers (25). The Backrest
Tubes and Backrest must be oriented exactly
as shown.
16
25
55
5
12
12
16
45
6
Wide
End
7
2
57
40
Adjustment
Tubes
6
8
2
11
Wide
End
15
28
27
15
9
10
10. Attach the Curl Pad (28) to the Curl Post (27) with
two M6 x 16mm Screws (15).
25
Adjustment
Tubes
17ÑLubricate
24
19
25
16
8. Lubricate the M10 x 178mm Bolt (17). Attach the
Backrest (6) to the Frame (2) with the Bolt, two
M10 Washers (24), and an M10 Nylon Locknut
(19). Do not overtighten the Nylon Locknut.
The Backrest must be able to pivot freely.
Secure the Backrest (6) to the Frame (2) with the
Adjustment Pin (40) through one of the three sets
of holes in the adjustment tubes. Secure the
Adjustment Pin with the Pin Clip (57).
Make sure the Adjustment Pin (40) is complete-
ly inserted through both holes in the adjust-
9. With the wide end of the Seat (11) positioned as
shown, attach the Seat to the brackets on the
Frame (2) with four M6 x 16mm Screws (15).