Filter
Top Products
3. Attach the Front Leg (8) to the Frame (2) with two
M10 x 65mm Bolts (18), two M10 Washers (24),
and two M10 Nylon Locknuts (19).
7
3
18
24
2
19
8
19
21
21
21
52
4
50
23
58
60
59
4
4
49
19
53ÐLubricate
8
13
48
30
5
35
14
2
19
24
6
48
4. Tap three 45mm Square Inner Caps (21) into the
indicated ends of the Leg Lever (4).
Tap a 1Ó Round Inner Cap (23) into the indicated
end of the Weight Tube (52).
Insert the Weight Tube (52) into the indicated hole
in the Leg Lever (4). Press a 1Ó Angle Cap (50)
onto the indicated end of the Weight Tube.
Press the Adapter Bushings (59) into the ends of
the Weight Adapter (60) as shown. Slide the
Weight Adapter onto the Weight Tube (52) and
secure it by pushing the Detent Pin (58) into the
Weight Tube as shown.
5. Lubricate an M10 x 72mm Bolt (53). Attach the
Leg Lever (4) to the Front Leg (8) with the Bolt
and an M10 Nylon Locknut (19). Do not overtight-
en the Nylon Locknut. The Leg Lever must be
able to pivot freely.
Attach the Narrow Spacer (30) to the Leg Lever
(4) with the M8 x 58mm Bolt (49), two M8
Washers (48), and an M8 Nylon Locknut (13).
Note: The Spacer will fit tightly inside of the
Leg Lever.
6. Attach the Frame (2) to the Lat Tower Base (35)
with two M10 x 67mm Bolts (14), two M10
Washers (24), and two M10 Nylon Locknuts (19).