Filter
Top Products
6
5. Lubricate an M10 x 68mm Bolt (31) with grease.
Attach the Leg Lever (8) to the Front Leg (3) with
the Bolt and an M10 Nylon Locknut (11). Do not
overtighten the Locknut; the Leg Lever must
be able to pivot easily.
5
3. Attach the Front Leg (3) to the Bench Frame (1)
using two Small Joint Plates (34), four M10 x
68mm Bolts (31), and four M10 Nylon Locknuts
(11).
Tighten the M10 Nylon Locknuts (11) used in
steps 1–3.
6. Press four 25mm Square Inner Caps (27) into the
ends of the Backrest Frames (33).
Attach the Backrest Bracket (5) to the Backrest
Frames (33) with four M6 x 38mm Screws (37)
and four M6 Nylon Locknuts (40). Make sure the
Backrest Frames are oriented so that the indi-
cated holes are closer to the bottom. Do not
tighten the Locknuts yet.
3
1
3
11
34
34
31
6
Lubricate
8
11
31
3
Holes
27
27
33
40
40
40
37
37
5
26
26
26
25
41
41
9
8
38
39
73
4
23
4. Press three 45mm Square Inner Caps (26) into
the Leg Lever (8). Press a 25mm Round Inner
Cap (23) into the indicated end of the Weight
Tube (9).
Attach the Weight Tube (9) to the Leg Lever (8)
with an M8 x 58mm Bolt (38), two M8 Washers
(41), a Short Spacer (39), and an M8 Nylon
Locknut (73).
Press an Angled Outer Cap (25) onto the back
end of the Weight Tube (9).