Filter
Top Products
7
7
7
37
37
36
36
Wide
End
Wide
End
33
36
37
10. Press two 19mm Round Inner Caps (18) into
each of the three Pad Tubes (17). Slide the Pad
Tubes through the indicated holes in the Front
Leg (3) and the Leg Lever (8).
Slide two Foam Pads (19) onto each Pad Tube
(17).
9
10
20
1
17
17
18
19
19
19
8
3
19
5
30
18
18
18
8
35
6
6
Lubricate
1
11
21
33
8. Lubricate an M10 x 180mm Bolt (35). Attach the
Backrest Frames (33) to the Bench Frame (1)
with the Bolt, two M10 Small Washers (6), and an
M10 Nylon Locknut (11). Do not overtighten the
Nylon Locknut; the Backrest must be able to
pivot freely.
Pull the Bench Knob (21) out as far as it will go.
Slide the Backrest Bracket (5) into the indicated
slot on the Bench Frame (1). Engage the Bench
Knob into an adjustment hole in the Backrest
Bracket.
Tighten the M10 Nylon Locknuts (11) and the
M6 x 36mm Screws (37) used in steps 6 and 7.
9. Attach the Seat (20) to the Bench Frame (1) with
four M6 x 16mm Screws (30). Make sure that
the Seat is oriented as shown.
7. Attach the Backrest (7) to the Backrest Frames
(33) with four M6 x 36mm Screws (37) and four
M6 Washers (36). Make sure that the Backrest
is oriented as shown. Do not tighten the
Screws yet.