Filter
Top Products
5
1.
Press two 50mm x 70mm Inner Caps (22) into
the ends of the Stabilizer (2).
Attach the Stabilizer (2) to the Bench Frame (1)
with two M10 x 60mm Carriage Bolts (32) and
two M10 Nylon Locknuts (11). Do not tighten the
Nylon Locknuts yet.
Note: Orient the Stabilizer (2) with the indents
around the holes on the bottom, and the warn-
ing decal in the indicated location.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
This manual is designed to ensure that the
weight bench can be assembled successfully
by anyone. Most people find that by setting
aside plenty of time, assembly will go smoothly.
Before beginning, make sure you under-
stand the information in the box above.
Note: Some parts described in the assem-
bly steps may be pre-assembled.
ASSEMBLY
1
32
Indents
Warning
Decal
22
22
1
2
11
2
3
4
10
10
10
11
31
31
13
2. Press two 50mm Square Inner Caps (10) into the
ends of the Front Leg Base (4). Press a 50mm
Square Inner Cap into the top of the Front Leg (3).
Attach the Front Leg (3) to the Front Leg Base (4)
using the two Front Leg Plates (13), four M10 x
70mm Bolts (31), and four M10 Nylon Locknuts
(11). Do not tighten the Nylon Locknuts yet.