Filter
Top Products
8
7. Lubricate the M10 x 178mm Bolt (17). Attach the
Backrest Tubes (5, 42) to the Frame (2) with the
Bolt, two M10 Washers (24), and an M10 Nylon
Locknut (19).
Secure the Backrest (6) to the Frame (2) with the
Adjustment Pin (32) through one of the three sets
of holes in the adjustment tubes. Secure the
Adjustment Pin with the Pin Clip (27).
Make sure the Adjustment Pin (32) is com-
pletely inserted through both holes in the
adjustment tubes.
8. With the wide end of the Seat (11) positioned as
shown, attach the Seat to the brackets on the
Frame (2) with four M6 x 16mm Screws (15).
2
32
5
42
19
27
24
17ÑLubricate
Adjustment
Tubes
6
7
2
11
Wide
End
15
8
9. Tap two 3/4Ó Round Inner Caps (9) into each Pad
Tube (10). Insert the Pad Tubes into the holes in
the Leg Lever (4) and the Front Leg (8). Slide two
Foam Pads (22) onto each Pad Tube.
10. Make sure that all parts are properly tightened before you use the weight bench. The use of all
remaining parts will be explained in USING THE WEIGHT BENCH on pages 9 and 10.
10
10
22
4
8
22
9
9