Filter
Top Products
3. Tap a 45mm Square Inner Cap (21) into the Front
Leg (8) as shown. Attach the Front Leg to the
Frame (2) with two M10 x 65mm Bolts (18), two
M10 Washers (24), and two M10 Nylon Locknuts
(19).
4. Tap two 45mm Square Inner Caps (21) into the
Leg Lever (4) as shown.
Tap a 1Ó Round Inner Cap (23) into the indicated
end of the Weight Tube (33). Insert the Weight
Tube into the Leg Lever (4). Make sure the
Weight Tube is angled up so that weights will
not slide off. Press the 1Ó Angled Cap (29) onto
the other end of the Weight Tube.
5. Lubricate the M10 x 72mm Bolt (14). Attach the
Leg Lever (4) to the Front Leg (8) with the Bolt
and an M10 Nylon Locknut (19). Do not overtight-
en the Nylon Locknut; the Leg Lever must be
able to pivot freely.
Attach the Spacer (37) to the Leg Lever (4) with
the M8 x 58mm Bolt (39), two M8 Washers (38),
and an M8 Nylon Locknut (13). Note: The Spacer
will fit tightly inside the Leg Lever.
6. Press four 1Ó Square Inner Caps (12) into the
Backrest Tubes (5, 26). Press two 1Ó x 2Ó Inner
Caps (36) into the adjustment tubes.
With the wide end of the Backrest (6) positioned
as shown, attach the Backrest Tubes (5, 26) to
the Backrest with four M6 x 38mm Screws (16)
and four M6 Washers (25). Note: The Backrest
Tubes and the Backrest must be oriented
exactly as shown.
7
3
18
24
2
19
8
19
21
21
21
33
4
29
23
4
4
38
39
38
37
13
19
14ÐLubricate
8
5
16
25
26
5
Adjustment
Tubes
12
12
16
16
36
6
Wide
End
6
25
25