Filter
Top Products
8
6. Lubricate the M10 x 70mm Bolt (26). Attach the Leg
Lever (4) to the Front Leg (8) with the Bolt, two M10
Washers (29), and an M10 Nylon Locknut (30).
Note: Do not overtighten the M10 Nylon Locknut
(10); the Leg Lever (4) must be able to pivot
freely.
7. Press two 19mm Round Inner Caps (12) into each
Pad Tube (10).
Insert the Pad Tubes (10) into the holes in the Leg
Lever (4). Slide two Foam Pads (22) onto each Pad
Tube.
8. Press a 25.4mm Square Inner Cap (18) into the
indicated end of each Backrest Tube (5).
Attach each Backrest Tube (5) to the Backrest (6)
with two M8 x 40mm Bolts (27) and two M8
Washers (17). Note the position of the indicated
holes in the Backrest Tubes; they must be ori-
ented as shown. Do not tighten the four Bolts
yet.
9. Press a 25.4mm Square Inner Cap (18) into each
end of the Support Tube (7). Set the Support Tube
into the highest set of adjustment brackets on the
Uprights (1, 15).
Lubricate the M10 x 130mm Bolt (9). Attach the
Backrest Tubes (5) to the Frame (2) with the Bolt,
two M10 Washers (29), and an M10 Nylon Locknut
(30). Do not overtighten the Nylon Locknut.
Rest the Backrest (6) on the Support Tube (7).
Tighten the Nylon Locknuts used in steps 1–3,
and the M8 x 40mm Bolts (27) used in step 8.
7
8
9
22
12
8
22
6
5
5
Holes
18
29
30
9
2
29
1
5
15
7
17
17
27
27
18
4
10
12
22
6
4
30
Lubricate
29
8
29
26