Filter
Top Products
7
7. Tap two 25mm Square Inner Caps (35) into each
of the two Backrest Tubes (5).
Attach each Backrest Tube (5) to the Backrest (6)
with two M6 x 38mm Screws (30) and two M6
Washers (26). Do not tighten the Screws yet.
8. Tap a 19mm Round Inner Cap (9) into each end
of the Support Rod (7). Insert the Support Rod
into one of the three upper sets of holes in the
Uprights (1). Rotate the Support Rod to the
locked position, with the locking pin wrapped
around the Upright. Note: Always insert the
Support Rod into the Uprights so that the
locking pin wraps around the back of the
Upright.
Lubricate the M10 x 135mm Bolt (36) with grease.
Attach the Backrest Tubes (5) to the welded tube
on the Frame (2) with the Bolt, two M10 Washers
(34), and an M10 Nylon Locknut (33). Do not
overtighten the Locknut; the Backrest Tubes
must be able to pivot easily.
Tighten the M6 x 38mm Screws (30) used in
step 7, and the Nylon Locknuts (17, 33) used
in steps 1 to 3.
9. Attach the Seat (11) to the brackets on the Frame
(2) with four M6 x 16mm Screws (29).
10. Press two 30mm Square Inner Caps (22) into the
ends of a Fly Arm (25). Press a 25mm Round
Inner Cap (24) into the end of the weight tube.
Slide a Weight Stop (28) onto the weight tube.
Assemble the other Fly Arm (not shown) in
the same manner.
7
5
30
26
26
30
6
8
9
10
35
35
9
9
11
29
29
28
24
22
Weight
Tube
22
25
2
34
5
36
7
1
2
Welded Tube
1
Locking
Pin
33
34