Filter
Top Products
8
6. Press two 75mm Bushings (26) into the top and
bottom of the Right Weight Rest (12).
Pull the Knob (30) out as far as it will go. Slide the
Right Weight Rest (12) onto the Right Upright (2)
and snap the Knob into an adjustment hole in the
Upright. Turn the Knob clockwise until tight.
Repeat this step with the Left Weight Rest (not
shown).
8. Press two 38.1mm x 76.2mm Inner Caps (49) into
the end of the Right and Left Frames (5, 6).
Attach the Right and Left Frames (5, 6) to the
Center Upright (3) with an M10 x 81mm Bolt (65)
and an M10 Nylon Locknut (77).
Attach the Right Frame (5) to the Center Frame
(4) with an M10 x 120mm Bolt (75), an M10
Washer (79), and an M10 Nylon Locknut (77).
Attach the Left Frame (6) to the Center Frame in
the same manner.
Do not tighten the M10 Nylon Locknuts (77) yet.
6
9
30
26
12
26
2
89
6
5
77
9
65
9. Press a 60mm Square Arched Inner Cap (89) into
the end of the Top Frame (9).
Attach the Top Frame (9) to the Right and Left
Frames (5, 6) with two M10 x 81mm Bolts (65)
and two M10 Nylon Locknuts (77). Do not tight-
en the Nylon Locknuts yet.
7
8
46
77
77
79
77
79
79
77
2
1
4
Decal
49
49
5
6
3
4
65
75
75
79
79
77
77
46
70
70
70
70
7. Press two 60mm Square Inner Caps (46) into the
top of the Left and Right Uprights (1, 2).
Orient the Center Frame (4) with the decal on the
side shown. Attach the Center Frame to the Left
and Right Uprights (1, 2) with four M10 x 78mm
Bolts (70), four M10 Washers (79), and four M10
Nylon Locknuts (77). Do not tighten the Nylon
Locknuts yet.