Filter
Top Products
10
14. Attach the Bench Frame (14) to the Back Leg
(39) with an M10 x 78mm Bolt (70), two M10 x
164mm Bolts (71), an M10 Washer (79), and
three M10 Nylon Locknuts (77). Do not tighten
the Nylon Locknuts yet.
17. Press two 38mm Square Inner Caps (44) into the
ends of the Support Leg (13).
Lubricate an M10 x 154mm Bolt (69). Attach the
Support Leg (13) to the Backrest Frame (16) with
the Bolt, two M10 Washers (79), and an M10
Nylon Locknut (77).
Lubricate an M10 x 164mm Bolt (71). Attach the
Support Leg (13) to the Back Leg (39) with the
Bolt, two M10 Washers (79), and an M10 Nylon
Locknut (77).
Lubricate two M10 x 45mm Bolts (76). Attach the
Backrest Frame (16) to the Sliding Seat Frame
(15) with the Bolts, two M10 Washers (79), and
two M10 Nylon Locknuts (77).
Do not overtighten the M10 Nylon Locknuts
(77); the Support Leg (13) and the Backrest
Frame (16) must be able to pivot easily.
16. Press four 25.4mm x 38.1mm Inner Caps (45)
into the Backrest Frame (16).
Orient the Backrest (38) as shown. Attach the
Backrest to the Backrest Frame (16) with four M6
x 16mm Bolts (72).
38
45
16
72
72
45
77
79
77
14
70
71
39
14
15. Attach the Leg Lever Bumper (54) to the Front
Leg (18) with the M4 x 19mm Screw (68) and an
M5 Washer (92).
Press a 38.1mm x 76.2mm Inner Cap (49) and a
2” x 3” Inner Cap (50) into the Leg Lever (19).
Lubricate an M10 x 102mm Bolt (91). Attach the
Leg Lever (19) to the Front Leg (18) with the Bolt
and an M10 Nylon Locknut (77). Do not over-
tighten the Nylon Locknut; the Leg Lever must
be able to pivot easily.
68
18
Lubricate
49
50
77
91
15
16
17
19
54
92
79
79
79
77
77
77
76
76
44
44
39
13
69
79
16
15
71
79