Filter
Top Products
16
81
44
79
66
59
WEIGHT RESTS AND SAFETY SPOTTERS
To use a barbell (not included) with the weight rack,
first move the Weight Rests (55, 80) and the Safety
Spotters (56, 81) to the correct heights for the exer-
cise to be performed. Engage the locking pins around
the Front Uprights (44).
80
Locking
Pin
ATTACHING THE LAT BAR
Attach the Lat Bar (59) to the Cable (79) with a Cable
Clip (66). For some exercises, it may be necessary to
attach the Chain (not shown) between the Cable and
the Lat Bar with two Cable Clips. Adjust the length
of the Chain between the Lat Bar and the Cable
so the Lat Bar is in the correct starting position
for the exercise to be performed.
Attach the Row Bar (not shown) to the Cable (79) in
the same manner.
71
70
69
50
ADDING WEIGHT TO THE WEIGHT RACK
To use the Weight Carriage (50), slide the desired
amount of weight (not included) onto the Carriage
Tubes (69). Secure the weight with two Weight Clips
(71).
Unused weights can be stored on the Storage Tubes
(70) on the weight rack.
WARNING: Always place both
Weight Rests (55, 80) and both Safety Spotters
(56, 81) at the same height. Make sure the lock-
ing pins are securely wrapped around the Front
Uprights (44) before setting a barbell (not includ-
ed) on them.
WARNING: Always place the same
amount of weight on each Carriage Tube (69)
and secure the weight with the two Weight Clips
(71).
Always store an equal amount of weight on each
side of the weight rack.