Weider C670 Home Gym User Manual


 
8
6. Pull out the Small Adjustment Knob (23) that is
nearer the Stabilizer (2). Insert the Backrest
Bracket (16) between the tubes on the Bench
Frame (1) and engage the Small Adjustment Knob
into one of the holes in the Bracket.
Pull out the Small Adjustment Knob (23) by the
Seat Bracket Sleeve (93). Insert the Seat Bracket
(17) into the
Seat Bracket Sleeve and engage the
Small Adjustment Knob into one of the holes in the
Bracket.
Lubricate the M10 x 102mm Bolt (99) with grease.
Attach the Seat Frame (7) and the Backrest Frame
(6) to the Bench Frame (1) with the Bolt, two M10
Washers (35), and an M10 Nylon Locknut (34). Do
not overtighten the Locknut; the Seat and
Backrest Frames must be able to pivot easily.
Attach an M10 x 19mm Bolt (102) to the round
hole in the Seat Bracket (17) with an M10 Nylon
Locknut (34).
Tighten the M10 Nylon Locknuts (34) used in
step 5.
7. Press three 50mm Square Inner Caps (13) and a
48mm Round Inner Cap (19) into the Leg Lever
(5).
Lubricate the M10 x 85mm Bolt (103) with
grease. Attach the Leg Lever (5) to the Leg Lever
Bracket (18) with the Bolt and an M10 Nylon
Locknut (34).
Loosen the Adjustment Knob (22) by turning it
counterclockwise several turns. Pull the Knob out
and slide the Leg Lever Bracket (18) into the Seat
Frame (7). Tighten the Adjustment Knob into the
Leg Lever Bracket.
8. Attach the Backrest (11) to the Backrest Frame
(6) with four M6 x 16mm Screws (29)
9. Attach the Seat (10) to the Seat Frame (7) with
four M6 x 16mm Screws (29)
6
23
6
34
99
16
35
2
35
Lubricate
1
23
7
7
5
13
13
19
13
18
34
34
103
22
7
8
9
11
10
29
6
29
Lubricate
29
17
93
102