Filter
Top Products
13
20. Press a 60mm Square Inner Cap (64) into the
Weight Guide Base (41).
Attach the Foot Plate (67) and the Weight Guide
Base (41) to the Center Base (39) with two M10 x
81mm Button Bolts (104) and two M10 Nylon
Locknuts (34). Do not tighten the Locknuts yet.
22. Slide the Weight Carriage Stop (65) onto the
Weight Guide Upright (42) as shown, and attach
it at the indicated hole with an M10 x 87mm Bolt
(106) and an M10 Nylon Locknut (34).
Attach the Weight Guide Upright (42) to the
Weight Guide Base (41) with two M10 x 75mm
Bolts (92), four M10 Washers (35), and two M10
Nylon Locknuts (34). Do not tighten the
Locknuts yet.
21. Attach the Center Top Frame (46) to the Left Top
Frame (48) with two M10 x 78mm Bolts (32) and
two M10 Nylon Locknuts (34). Make sure the
decal is in the indicated location. Do not tight-
en the Locknuts yet.
Attach the Center Top Frame (46) to the Right
Top Frame (47) with two M10 x 78mm Bolts (32)
and two M10 Nylon Locknuts (34). Do not tight-
en the Locknuts yet.
20
67
104
39
34
34
41
64
21
46
Decal
47
48
34
32
34
32
22
65
35
35
35
92
106
Hole closer
to bottom
41
Hole
42
34
34