Filter
Top Products
22
TIGHTENING THE CABLES
W
oven cable, the type of cable used on the weight
system, can stretch slightly when it is first used. If there
is slack in the cables before resistance is felt, the
cables should be tightened.
See drawing A. Slack can be removed by moving the
90mm Pulley (38) and Cable Trap (91) to a higher set
of holes in a Double “U”-Bracket (56). Remove the
M10 Nylon Locknut (70) and the M10 x 50mm Bolt (62)
from the Cable Trap, the Pulley, and the Double “U”-
Bracket. Re-attach the Pulley and the Cable Trap to
the new set of holes in the Double “U”-Bracket with the
Bolt and Locknut.
Make sure that the Cable Trap is
in the proper position and that the Cable and
Pulley move smoothly.
Move the 90mm Pulley (38) in the other Double
“U”-Bracket (56) in the same manner.
See drawing B.
Slack can be removed by moving the
90mm Pulley (38) and the Cable Trap (91) to the high-
er set of holes in a “U”-Bracket (85). Remove the M10
Nylon Locknut (70) and the M10 x 50mm Bolt (62)
from the Cable Trap, the Pulley, and the “U”-Bracket.
Re-attach the Pulley and the Cable Trap to the higher
set of holes in the “U”-Bracket with the Bolt and
Locknut. Make sure that the Cable Trap is in the
proper position and that the Cable and Pulley
move smoothly.
Move the 90mm Pulley (38) in the other “U”-Bracket
(85) in the same manner.
See drawing B. Slack can also be removed from the
cables by tightening the M6 Nylon Locknuts (26)
attaching a cable to either “U”-Bracket (85), or the
Small “U”-Bracket (79). To do this, you may need to
remove the 90mm Pulley (38) from the “U”-Bracket, or
remove the Small “U”-Bracket from the W
eight
T
ube
(not shown). Make sure that the cables are not too tight
or the
T
op W
eight (74) will be lifted of
f the weight stack.
ADJUSTING THE LEG PRESS PLA
TE
To adjust the Leg Press Plate (31), remove the Leg
Press Pin (87) from the Leg Press Frame (30) and the
Adjustment
T
ube (88). Move the Tube to the desired
position and secure it in place with the Pin. Be sure
the Pin is turned to the locked position around the
Leg Press Frame.
70
56
56
91
62
38
26
85
62
85
79
74
70
38
A
B
30
31
88
87