Filter
Top Products
15
29. Wrap the Long Cable (73) around a “V”-Pulley (21)
in the direction shown. Attach the “V”-Pulley and a
Large Cable Trap (14) to the small tube on the
Press Seat Frame (52) with a 3/8” x 3 1/4” Bolt (28),
a 3/8” Flat Washer (17) and a 3/8” Nylon Locknut
(4). Note: The small tube has three adjustment
holes. Mount the “V”-Pulley in the hole farthest
from the Upright. Make sure the Cable Trap is
oriented as shown.
30. Route the Long Cable (73) back through the opening
in the Press Frame (53) and wrap the Long Cable
around a 3 1/2” Pulley (5) in the direction shown.
Then, route the Long Cable back through the opening
in the Press Frame.
Attach the 3 1/2” Pulley (5) and a Cable Trap (39) to
the indicated hole in the Press Frame (53) with a 3/8”
x 3 1/4” Bolt (28), 3/8” Flat Washer (17), and a 3/8”
Nylon Locknut (4). Make sure the Pulley is mount-
ed on the inside of the Press Frame. Make sure
the Cable Trap is oriented as shown.
31. Route the Long Cable (73) around a 3 1/2” Pulley (5)
and back through the opening in the Press Frame
(53).
Remove the 3/8” Nylon Locknut (4) from the 3/8” x 4
3/4” Bolt (23) that was inserted in step 27. Attach the
Pulley and a Cable Trap (39) to the Bolt and secure
the Pulley with the 3/8” Nylon Locknut (4). Make sure
the Cable Trap is oriented as shown.
32. Note: Lift the top weight on the weight stack in
order to create slack in the Long Cable before
beginning this step.
Attach the Long Cable (73) to the Leg Lever (49),
slipping the looped end of the Cable through the
looped end of the Eye Bolt (83).
14
17
4
28
21
59
52
73
30
28
53
73
4
5
39
17
29
73
53
5
4
23
39
49
31
32
73
83